Hampton Bay 14413 Bedienerhandbuch PDF herunterladen (Seite 16)

□ Check that all blade and blade arm screws are secure.

□ Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a

point on the ceiling above the tip of one of the blades. Measure from a point on the center of each blade

to the point on the ceiling. Rotate the fan until the next blade is positioned for measurement. Repeat for

each blade. Any measurement deviation should be within 1/8 in. Run the fan for ten minutes.

□ Use the enclosed blade balancing kit if the blade wobble is still noticeable.

The fan wobbles.

Problem

Solution

The fan will not start.

The fan sounds noisy.

WARNING: Make sure the power is off at the electrical

panel box before you attempt any repairs. Refer to the

section “Making the Electrical Connections” on page 9.

□ Check main and branch circuit fuses or breakers.

□ Check line wire connections to the fan and switch wire connections in the switch housing.

□ Make sure all motor housing screws are snug.

□ Make sure the screws that attach the fan blade arm to the motor hub are tight.

□ Make sure wire nut connections are not rattling against each other or the interior wall of the switch

housing.

□ Allow a 24-hour "breaking-in" period. Most noises associated with a new fan disappear during this time.

□ If using the ceiling light kit, make sure the screws securing the glassware are tight. Check that the light

bulb is also secure.

□ Make sure there is a short distance from the ceiling to the canopy. It should not touch the ceiling.

□ Make sure your ceiling box is secure and rubber isolator pads are used between the mounting bracket

and outlet box.

Troubleshooting

1 2 ... 11 12 13 14 15 16 17 18

Keine Kommentare

Hampton Bay 14413 Bedienerhandbuch Seite 16