Hampton Bay YG177H-CLP Bedienerhandbuch PDF herunterladen (Seite 13)

10

Installing the

Light Kit

Remove the 1 of 3 screws from the switch

housing and keep it for future use. Loosen the

other 2 screws. (Do not remove)

While holding the LED light plate under your

fan, make the 2-pin wire connection:

- Red to red

- Black to black

Place the key holes on the LED light plate over

the 2 screws previously loosened from the

switch housing, turn LED light plate until it

locks in place at the narrow section of the key

holes. Secure by tightening the 2 screws

previously loosened and the one previously

removed. (Fig. 15)

Raise glass shade up against switch housing and

secure it to fan by turning glass clockwise until

snug. DO NOT OVERTIGHTEN. (Fig. 15)

1.

2.

3.

4.

Wire Connection

Plugs

LED Light Plate

Screws

Glass Shade

Switch Housing

Figure 15

NOTE

BEFORE STARTING INSTALLATION, DISCON-

NECT THE POWER BY TURNING OFF THE

CIRCUIT BREAKER OR REMOVING THE FUSE AT

FUSE BOX. TURNING POWER OFF USING THE

FAN SWITCH IS NOT SUFFICIENT TO PREVENT

ELECTRIC SHOCK.

WARNING

SHUT OFF THE POWER SUPPLY BEFORE REMOV-

ING OR REPLACING LAMP. IN HANDLING OF

LED BULB, CARE SHOULD BE TAKEN NOT TO

TOUCH IT WITH YOUR BARE HANDS. OIL

RESIDUE WILL SHORTEN THE LIFE OF THE LED

BULB. IF YOU ACCIDENTALLY COME INTO

CONTACT, WIPE THOROUGHLY WITH A CLEAN,

LINT-FREE, COTTON CLOTH. ALLOW THE BULB

TO COOL OFF FOR 10 MINUTES BEFORE CHANG-

ING THE BULB. USE LIGHT BULB IN ACCOR-

DANCE WITH THE FAN'S SPECIFICATION.

1 2 ... 8 9 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare