Hampton Bay EC410ABZ Installationsanleitung PDF herunterladen (Seite 2)

Thank you for purchasing this Hampton Bay interior track pendant. This product has been manufactured with the highest standards of safety

and quality.

FEATURES:

1. Track pendant can be installed any locations into the track section.

2. Track Pendant is adjustable in length and comes complete with a Do-It-Yourself Pendant Adapter and wire; the wire can be cut to desired

lengths for different applications and ceiling heights.

QUESTIONS, PROBLEMS, MISSING PARTS:

Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com. Please

reference SKU828650, UPC008938241090.

GENERAL

All electrical connections must be in accordance with local codes, ordinances or national electrical codes. If you are unfamiliar with methods of

installing electrical wiring, secure the services of a qualified electrician. Before starting installation, disconnect the power by turning off the

circuit breaker or removing the fuse at fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.

Note: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and situations that may

occur. It must be understood that common sense, caution and care are factors that cannot be built into any product. These factors must be

supplied by the person(s) caring for, installing and operating the fixture. If at any time you are uncomfortable or are unsure of what to do,

please contact a qualified licensed electrician for further assistance.

IMPORTANT SAFETY INSTRUCTIONS

1. Read all instructions.

2. Do not install this lighting system in a damp or wet location.

3. Before energizing make sure that the lighting system is clear of all material which could cause a direct short and check all electrical

connections to make sure they are tight.

4. Do not install any part of this system (TRACK) less than 7 feet (2.2m) above floor.

5. To reduce the risk of fire and burns, do not install this lighting system where non insulated open bus-bar conductors can be shorted or

contact any conductive metals.

6. To reduce the risk of fire and overheating, make sure all connections are tight.

7. Turn off electrical power before modifying the light system in anyway.

8. For installation with HAMPTON BAY EC series track only.

9. CAUTION – To reduce the risk of a burn during re-lamping, remove from the track before re-lamping

10. Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.

11. DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION.

SAVE THESE INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):

Ladder Safety goggles Wire stripper Gloves Flathead screwdriver Phillips screwdriver

Electrical tape

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

x1 canopy x1 Pendant

Fixtures x1 Hardware Packet x1 A Bulb

Box

1 2 3 4 5 6 7 ... 11 12

Keine Kommentare

Hampton Bay EC410ABZ Installationsanleitung Seite 2