Hampton Bay GVQ9713A-2 Installationsanleitung PDF herunterladen (Seite 6)

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

3ea Wire Connectors (#15) 1ea Ground Screw (#16) 1ea Hex Nut (#17)

1ea Mounting Strap (#18) 1ea Nipple (#19) 2ea Outlet Box Screws (#20)

INSTALLATION INSTRUCTIONS:

1. Screw the Nipple (#19) a half-inch into the Mounting Strap (#18). Tighten the Hex Nut (#17)

against the Mounting Strap (#18) to secure the Nipple (#19). Attach the Mounting Strap (#18)

to the Outlet Box (#14) using the two Outlet Box Screws (#20). [Make sure the longer end

of the Nipple (#19) is facing outside when the Mounting Strap (#18) is attached to the Outlet

Box (#14).]

2. Adjust the Chain (#3) to required height by lifting the fixture and attaching the Quick Link

(#21) to the Loop (#5) and to a link of Chain (#3) closer to the ceiling. The fixture can be

raised and lowered in this manner until the desired height is achieved. Next, use pliers and a

screwdriver to twist open (cover the chain with cloth to prevent damage to the link finish)

the first unused link of Chain (#3). Remove and save the excess chain. Pull the excess

fixture wires through the Nipple (#19) into the Outlet Box (#14). Wires may be left at full

length or shortened as determined by space in the Outlet Box (#14) to make the wire

connections.

3. Wrap the ground wire from the fixture around the Ground Screw (#16) on the Mounting

Strap (#18), and then connect the ground wire from the fixture to the ground wire from the

Outlet Box (#14). Connect the wire without writing on it (with raised ribs) from the fixture

to the white wire (neutral wire) from the Outlet Box (#14). Connect the wire with writing on

it from the fixture to the black wire (live wire) from the Outlet Box (#14). Cover the three

connections using the three Wire Connectors (#15). Wrap the three wire connections with

electrical tape for a more secure connection. Position the wires back inside the Outlet Box

(#14). Note: If you have electrical questions, consult your local electrical code for approved

grounding methods.

4. Place the Canopy (#1) over the Nipple (#19) all the way to the ceiling. Tighten the Ring (#4)

onto the Screw Collar Loop (#2) until the Canopy (#1) is held firmly against the ceiling.

5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light

switch on to activate the fixture.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Keine Kommentare

Hampton Bay GVQ9713A-2 Installationsanleitung Seite 6