Hampton Bay 51564 Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(standard mount)

Wrapping the extra wire

□ Gently wrap the excess wire around the mounting bracket.

□ Secure with electrical tape.

NOTE: Follow this step ONLY if you did not cut the extra length off

from the wires coming from the ceiling fan.

□ Align the locking slots of the ceiling canopy (C) with the two

screws (II) in the mounting bracket (A). Push up to engage the

slots and turn clockwise to lock in place.

□ Firmly tighten the two mounting screws.

□ Install the two mounting screws (saved from Assembly Step

1 “Prepairing for mounting”) into the holes in the canopy

WARNING: When using the standard ball/downrod mounting, the

tab in the ring at the bottom of the mounting bracket must rest in

the groove of the hanger ball. Failure to properly seat the tab in

the groove could cause damage to the wiring.

WARNING: The locking slots of ceiling canopy are provided only

as an aid to mounting. Do not leave the fan assembly unattended

until all four canopy screws are engaged and rmly tightened.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

Hampton Bay 51564 Gebrauchs- und Pflegehandbuch Seite 10