Hampton Bay 51564 Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 8)

Assembly - Close-To-Ceiling Mount

Assembly - Hanging the Fan

□ Remove three of the six screws and lock washers (KK) (every

other one) securing the motor collar (K) to the top of the fan-

motor assembly (D).

□ Route the wires exiting the top of the fan-motor assembly (D)

through the rubber gasket (EE) aligning the holes in the rubber

gasket (EE) with the three screws holes in the fan-motor

assembly( E), then through the canopy (C) (make sure the slot

openings are on top).

□ Place the canopy (C) over the collar at the top of the fan-motor

assembly (D), aligning the mounting holes with the holes in

the motor and fasten using the three screws and lock-washers

(KK) removed previously. Tighten the mounting screws

securely.

Attaching the fan to the electrical

box

□ Pass the 120-Volt supply wires through the center hole in the

slide-on mounting bracket (A).

□ Install the slide-on mounting bracket (A) on the outlet box by

sliding the slide-on mounting bracket (A) over the two screws (LL)

provided with the outlet box. If necessary, use leveling washers

(not included) between the slide-on mounting bracket (A) and

the outlet box. The at side of the slide-on mounting bracket (A)

should face toward the outlet box, as shown.

□ Securely tighten the two mounting screws (LL).

WARNING: To reduce the risk of re, electric shock

or personal injury, mount to an outlet box marked

“Acceptable for fan support of 35 lbs. (15.9 kg) or less,”

and use the screws provided with the outlet box.

Routing the wiresPreparing for mounting

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (II) located in the “L shaped”

slots.

□ Remove and save the two canopy screws (HH) in the round

holes. This will enable you to remove the mounting bracket

(A).

□ Remove the decorative canopy bottom cover (J) from the

canopy (C) by pressing the three studs.

NOTE: The mounting bracket (A) is designed to slide into

place on an outlet box with the outlet box screws (LL).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

Hampton Bay 51564 Gebrauchs- und Pflegehandbuch Seite 8